Try before you buy
A free test piece
A two-part phone holder in 9 mm plywood. Try the whole process: cut it at a shop and see how it fits together. Without paying anything.
The most common doubt is “what if the shop doesn't cut it right?”
That is why we made a small piece with the same kind of joint the packs use. You go through the whole process with a test file and only then decide whether to buy a wall panel.
01Download the DXF and the manual
Instantly, with your email. They are two small files.
02A CNC shop cuts it
An offcut of 9 mm plywood. It is a few minutes of cutting: many shops will not charge you for it.
03See how it fits together
The tab press-fits into the slot. If that closes, a full pack closes the same way.
What you get
- dxf
DXF cutting file
Two parts in mm, CORTE and PERFORACION layers. This is what you send to the shop.
- pdf
Mini PDF manual
One page: measurements, what to ask the shop and how it fits together.
Fits in a 220 × 120 mm offcut. 6 mm straight bit, the same one every design calls for.